День тестирования в лаборатории.
Изделие: профильные фасады для ламинированной кухонной мебели.  …
Цель: эффективность и стабильность.
Когда речь заходит о нанесении покрытий, существует еще один важный момент, помимо всего прочего – расхо…
Any material, bearing in mind two conditions.
Firstly, spray coating ensures all sides of the piece are covered. Secondly, the product shape is unimportant and, since it is not a contact-type coating, different tolerances between products are compensated for automatically.
While quality is subjective, it is possible to measure the quantity of coating applied at each point. It's also possible to measure gloss or matt levels using appropriate instruments.
Lacquer is the key factor to be monitored, as it is the most expensive aspect of the process. Any variations can make the process more or less sustainable and also have an impact on process quality.
This depends on the type of machine, the type of conveyor (paper or continuous belt) and the type of filtration (paper or water).
Differences relate to the degree of freedom, the type/number of movements they can make and the angles they can achieve.
With paper-based filtration, the filters must be replaced; water-based filtration requires no maintenance as the system continuously "self-cleans" during operation.
Thanks to flow control systems, you certainly can. However, the coating quality is not necessarily strictly linked to lacquer consumption.
Space requirements are similar to those of a manual booth. All tasks can be performed by the same worker who, instead of coating, operates the machine.
As with manual coating system, maintenance largely concerns the pump and spray guns (i.e. the coating application system).
In the case of a machine with continuous belt conveying, cleaning and retrieval system maintenance is also required.
Machines with water filtration will also require maintenance of the continuous filtration device.
Our network of distributors and branches stretches across the globe. Finding the service you need in your country should be easy. Alternatively, we can send spare parts and technicians directly from our headquarters in just a few days.
Yes, dedicated procedures mean they can be managed quickly on all our machines.
In the case of oscillating spray machines, all you need to do is provide some parameters and, thanks to the incoming piece reading system, each piece is then coated according to the information entered.
With robots, different work modes are possible so it is necessary to define the way and the order in which you wish to execute strokes and whether to coat certain product parts or not. Programmed this way, each piece loaded and read by the reading system is automatically processed as per the saved information.
Of course. This technology was specifically designed to coat surfaces and edges.
The range of finishes is practically unlimited, also because finishing is more closely linked to the product being coated.
It is advisable to have a drying system connected to the machine. This ensures more consistent results. It also lowers the percentage of waste compared to simple air drying, which involves some risk of contamination. What's more, some finishes require special drying conditions (temperature, air speed) so an oven is definitely recommended where certain finishes are needed.
By raising the number of machines or lines, and by increasing (within certain limits) the speed of the machine itself.
Extremely. Just replacing the product in the spray guns and making a few other adjustments can radically alter the coating. Flexibility is even more pronounced where paper conveying machines are used, as there are no tasks related to the lacquer retrieval and belt cleaning system.
Sustainability varies from one machine to the next, but depends more on the actual coating process.
Yes. You can order spare parts by email or phone. You can also use cMaster, our dedicated spare parts ordering app.